Stuart-turner Techflo Turbo 15T Uživatelský manuál stáhnout pdf (Strana 12)

- 12 -

Cont ...

4.23 Supply Cord Replacement:

The supply cord and internal wiring within the terminal box are

routed and secured to ensure compliance with the electrical

standard EN 60335-1. It is essential that prior to any disturbance

of this internal wiring, all cable routing and securing details are

carefully noted to ensure re-assembly to the same factory pattern

is always maintained.

If the supply cord is to be changed or is damaged, it must be replaced with a

special cord assembly available from Techflow or one of their approved repairers.

On disassembly note the cord retention and routing system. Re-assemble to the

same pattern.

For information on cable connection consult the wiring diagram and cable gland

fitting instructions.

The wire which is coloured blue must be connected to the terminal which is

marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is

marked with the letter L or coloured red.

4.21 Wiring Diagrams:

 Parallel wiring of two single pumps is not recommended.

Model Fuse Size (AMPS)

All other models 5

4.22 Fuses: The following fuse size should be used with the appropriate pump:

MAIN WINDING

THERMOTRIP

CAPACITOR

START WINDING

FLOWSWITCH

REED (S2)

BLUE

BROWN

BLACK

GREEN / YELLOW

BLUE

BROWN

230 VAC/1PH/50Hz

SUPPLY

FLOWSWITCH

REED (S1)

MAIN WINDING

THERMOTRIP

CAPACITOR

START WINDING

FLOWSWITCH

REED (S2)

BLUE

BROWN

BLACK

RED

GREEN / YELLOW

BLUE

BROWN

230 VAC/1PH/50Hz

SUPPLY

Single Models

Fig. 11

Twin Models

Fig. 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Komentáře k této Příručce

Žádné komentáře

Stuart-turner Techflo Turbo 15T Uživatelský manuál Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Čerpadla Stuart-turner Techflo Turbo 15T